The HQ Diving 6″ Rubber LP Inflator Hose is a short replacement option for a compatible low-pressure inflation setup. Its compact length suits equipment arrangements where the regulator connection and inflator sit close together, helping avoid an unnecessarily long loop of hose.
Features and benefits
- Short 6-inch length: provides a compact connection where a longer inflator hose would leave excess hose. Choose it only when it allows the movement your equipment needs.
- Rubber hose construction: offers a conventional rubber alternative for divers replacing a short LP inflator hose.
- Quick-disconnect inflator coupling: the knurled sliding collar gives you a gripping surface when connecting or disconnecting a compatible inflator.
- Black finish: keeps the hose visually consistent with a black regulator and inflation setup.
Fit and compatibility
Match both hose-end connections to your first stage and inflation equipment before ordering. A hose being described as an LP inflator hose does not guarantee that it fits every BCD, drysuit valve or combined inflator and alternate air source.
Check the routing with your equipment in its normal position. The hose must reach without tension, sharp bends or pulling on either fitting. Have a qualified dive equipment technician check compatibility, fit the hose and complete a leak and function check before use. Connect only to the correct low-pressure supply.
What’s included
One HQ Diving 6-inch rubber LP inflator hose. Regulators, inflators and other equipment are sold separately.
Care and storage
Rinse the exterior with fresh water after use, following your regulator and inflator instructions. Keep disconnected ends clean and protected from water, sand and debris. Allow the hose to dry in the shade and store it loosely without tight bends or weight resting on it.
Before each dive, inspect the rubber, crimps and fittings for cracks, bulges, corrosion or leaks. Stop using a damaged or leaking hose and have it checked by a qualified technician.
Unsure whether a 6-inch hose will suit your setup? Contact Dive Gear Australia for help matching the connection and length, or browse our dive hose range.
Technical Specs
| Brand | HQ Diving |
|---|---|
| Hose type | Low-pressure (LP) inflator hose |
| Nominal length | 6 inches (approximately 15 cm) |
| Hose material | Rubber |
| Colour | Black |
| Quantity supplied | One hose |




Reviews
There are no reviews yet.