Apeks Pressure Gauge + Compass Console
The Apeks Pressure Gauge and Compass Console puts cylinder pressure and navigation in one retained assembly. It suits a setup where depth and dive time are on your wrist, while pressure and heading remain easy to check together.
Features and benefits
- Luminous pressure display. The dial retains light after illumination, helping you see the pressure pointer as ambient light falls.
- Compass with side windows. Two viewing windows allow a useful line of sight from either side, helping you hold the instrument comfortably when following a heading.
- Ratcheting compass bezel. The bezel gives you a reference for the intended bearing and a positive feel when adjusting it with gloves.
- Protected gauge construction. A nickel-plated brass pressure-gauge body and anti-splinter polycarbonate window protect the instrument during ordinary handling.
- Integrated retaining loop. The loop provides a place for a suitable retainer, keeping the console close while allowing enough movement to read it.
- Overpressure capsule. The housing includes pressure relief for an internal fault. Keep the relief path unobstructed.
Setup and compatibility
This is a pressure-and-compass console; it does not contain a depth gauge. Have the HP connection installed and leak-checked on a compatible regulator. Route the hose so the console can be held naturally, and keep magnets and nearby metal away from the compass during a bearing check.
The pressure gauge uses oxygen-compatible materials, but this standard version is not supplied oxygen-clean. Use only gases approved for the complete configured system and have any oxygen-service requirements assessed by an appropriately qualified technician.
Care, rinsing and storage
After each dive, rinse the gauge and hose thoroughly with fresh water. Keep the complete regulator assembled, connected to a secured dive cylinder and pressurised while washing and rinsing, with the stages, gauge and connected hoses submerged. This helps keep water out of the pressure system. Lift the equipment out and dry the cylinder connection before depressurising and disconnecting; fit the first stage’s clean, dry dust cap.
Let the equipment dry in the shade, then store it with the hose in a relaxed curve. Protect the instrument from impacts and avoid lifting the regulator or cylinder by the gauge hose. Before diving, inspect the lens, hose and fittings, check for leaks and confirm that the needle responds normally and returns to zero when fully depressurised. Have damage, internal moisture or an unreliable reading checked by an authorised technician.


Reviews
There are no reviews yet.